Cannot use the same view multiple times on a form
kbt129649
PRODUCTK2 blackpearl 4.6.11
BASED ONK2 blackpearl 4.6.11
TAGSSmartForms Designer
Rules
This article was created in response to a support issue logged with K2. The content may include typographical errors and may be revised at any time without notice. This article is not considered official documentation for K2 software and is provided "as is" with no warranties.
LEGACY/ARCHIVED CONTENT
This article has been archived, and/or refers to legacy products, components or features. The content in this article is offered "as is" and will no longer be updated. Archived content is provided for reference purposes only. This content does not infer that the product, component or feature is supported, or that the product, component or feature will continue to function as described herein.
Issue
Using a single view multiple times on a form causes the form rules pointing to the views to behave inconsistently, because of the naming convention being incorrect.Symptoms
The rule naming conventions are not lining up with the used views in a form.
Resolution
This is as per design, K2 sees all the views as one since it is the same view that is being used over and over again, renaming the views inside on the form does not change the way K2 sees them as the views are still seen as the original view contained in the form. The suggestion is to rather perform a "save as" on the view and then use the saved as views as separated views inside of the form to avoid this type of behavior.
